Follow us on Facebook!

O-Ring Installation Guides

Scroll through the list below to find your headlamp model. If you do not see your specific model listed, find the one that best fits. The important part to check is if, and where, the headband slot is on the lamp as well as how large the base is relative to the Goggle Guard® clip. If your headlamp isn't listed below and none of the shown methods work for you, please contact us with the brand and model of your lamp.

HL3W

Insert o-ring into the slot as shown in Fig.1, then pull it to the upper corner of the slot as shown in Fig 2. Stretch the o-ring across the back of the clip and insert into the opposite slot. This is easier if you hook the lower half of the o-ring under the top-left corner of the clip, then pull down and insert into the slot as shown in Fig. 3. Pull the o-ring to the top of the left slot as shown in Fig. 4. Pull the lower band down and under the lower-left corner of the clip as shown in Fig. 5. Repeat on the lower-right side as shown in Fig. 6.

Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6

Pelican HeadsUP Lite 2620

Hook o-ring over headlamp edge as shown in Figure 1, then stretch across the back of the Goggle Guard™ clip and over the opposite edge as shown in Figure 2.


Figure 1
Figure 2

Pelican 2740, 2745, 2750, 2755, 2760 & 2765

Hook o-ring over headlamp edge as shown in Figure 1, then stretch across the back of the Goggle Guard™ clip and over the opposite edge as shown in Figure 2.


Figure 1
Figure 2

Princeton Tec Vizz II, EOS II, Aurora 3, Quad II

Insert o-ring into the slot and twist so it is parallel and inside the slot as shown in Fig 1 & Fig 2. Lay the assembly face down and pull the left side of the o-ring over and around the left corner of headlamp as shown in Fig 3 making sure the o-ring is sitting in the slot. Pull o-ring down over the lower left corner of clip as shown in Fig 5. The o-ring should look like Figures 4 and 5 when installed correctly.


Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6

Quarrow

Insert o-ring into the headlamp’s slot as shown in Fig. 1, then stretch it around the GGG clip and hook through opposite slot as shown in Fig. 2 & Fig. 3. Pull the lower left side of o-ring down and under the GGG clip as shown in Fig. 4, repeat for the lower right side as shown in Fig. 5.


Figure 1
Figure 2
Figure 3
Figure 4
Figure 5

Streamlight Enduro

Insert o-ring into the headlamp’s slot as shown in Fig. 1, then stretch it around the GGG clip and hook through opposite slot as shown in Fig. 2 & Fig. 3. Pull the lower left side of o-ring down and under the GGG clip as shown in Fig. 4, repeat for the lower right side as shown in Fig. 5.


Figure 1
Figure 2
Figure 3
Figure 4
Figure 5

Streamlight Septor

Insert o-ring into the slot as shown in Fig 1 & 2.With the assembly face down, stretch the o-ring over and through the left slot as shown in Fig. 3. Pull the o-ring down and under the lower-left corner of the Goggle Guard clip as shown in Fig.4, repeat for the lower-right as in Fig. 5.


Figure 1
Figure 2
Figure 3
Figure 4
Figure 5